Re: [RCSE] Servo extensions

["Walter Lynch" <w.r.lynch@xxxxxxxxxxxxxxxx>]

Rob, good stuff about the servo connectors but you failed to mention one
must have the
eyes of a eagle, the dexterity of a surgeon, and way more patience  than I
have to
crimp those tiny pins w/ that tool.  I make connectors up using the same
stuff but almost always count on two attempts/two pins to get one pin
properly crimped-gets expensive
after a while.  Is there anything out there that can just be soldered?
Walter
-----Original Message-----
From: Rob Crockett <rcrock@xxxxxxxx>
To: Soaring@xxxxxxxxxx <Soaring@xxxxxxxxxx>
Date: Tuesday, May 23, 2000 9:46 PM
Subject: [RCSE] Servo extensions


>Here's a few words and pictures about making servo connectors and
>extensions, with some alternatives, collected from RCSE over the years.
>
>http://www.ncws.com/rcrock/connector.htm
>
>Rob Crockett
>Grass Valley, CA
>
>RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and
"unsubscribe" requests to soaring-request@xxxxxxxxxx
>


RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and "unsubscribe" requests to soaring-request@xxxxxxxxxx