Re: [RCSE] Servo extensions

[Simon Van Leeuwen <lomcovak@xxxxxxxxxxxxxxxxxxx>]

Although (in this case) a properly soldered joint can have the same
electrical/mechanical properties as a crimped joint, it takes someone
who has lots of the soldering skill necessary to achieve it. Usually,
too much solder is applied that serves no purpose other than to wick
down the lead creating a point of failure.
Crimp connectors offer the most consistancy and repeatability
(industry-wide), when done correctly. Failure to use the proper
equipment may have very undesirable consequences. 
I build servo extensions and sell them to my IMAC friends for large
powered aerobats using high-tech wiring/cabling (twisted, also single or
double shielded for extraneous EMI/RFI, 24ga-high strand count) and
quality-crimped connectors. These are made to your specifications.
And no (unfortunately), there is really nothing out there that will
allow someone who holds an iron on an irregular basis to do a
satisfatory job every time :^)


Walter Lynch wrote:
> 
> Rob, good stuff about the servo connectors but you failed to mention one
> must have the
> eyes of a eagle, the dexterity of a surgeon, and way more patience  than I
> have to
> crimp those tiny pins w/ that tool.  I make connectors up using the same
> stuff but almost always count on two attempts/two pins to get one pin
> properly crimped-gets expensive
> after a while.  Is there anything out there that can just be soldered?
> Walter
> -----Original Message-----
> From: Rob Crockett <rcrock@xxxxxxxx>
> To: Soaring@xxxxxxxxxx <Soaring@xxxxxxxxxx>
> Date: Tuesday, May 23, 2000 9:46 PM
> Subject: [RCSE] Servo extensions
> 
> >Here's a few words and pictures about making servo connectors and
> >extensions, with some alternatives, collected from RCSE over the years.
> >
> >http://www.ncws.com/rcrock/connector.htm
> >
> >Rob Crockett
> >Grass Valley, CA
> >
> >RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and
> "unsubscribe" requests to soaring-request@xxxxxxxxxx
> >
> 
> RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and "unsubscribe" requests to soaring-request@xxxxxxxxxx
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and "unsubscribe" requests to soaring-request@xxxxxxxxxx