[Xen-devel] PAE dom0 is broken with the default config

Hi Keir, Ian,

I built PAE Xen with the default config, and it is not booting. Log is bellow. If I replace the linux-defconfig_xen_x86_32 file with the linux-defconfig_xen0_x86_32 before building then dom0 is able to boot and see more than 4Gig memory. This looks like a dom0 kernel config issue. Do you care PAE dom0 for 3.0.2 with the default config? Is anybody working on this?

IP route cache hash table entries: 262144 (order: 8, 1048576 bytes)

TCP established hash table entries: 524288 (order: 10, 4194304 bytes)

TCP bind hash table entries: 65536 (order: 7, 524288 bytes)

TCP: Hash tables configured (established 524288 bind 65536)

TCP reno registered

NET: Registered protocol family 8

NET: Registered protocol family 20

Using IPI No-Shortcut mode

Freeing unused kernel memory: 172k freed

scsi_mod: no version for "struct_module" found: kernel tainted.

SCSI subsystem initialized

ACPI: PCI Interrupt 0000:00:1f.2[A] -> GSI 18 (level, low) -> IRQ 17

ata1: SATA max UDMA/133 cmd 0x0 ctl 0xC402 bmdma 0xBC00 irq 17

ata2: SATA max UDMA/133 cmd 0x0 ctl 0xC002 bmdma 0xBC08 irq 17

ata1: dev 0 ATA-6, max UDMA/133, 312581808 sectors: LBA48

ata1: dev 0 configured for UDMA/133

scsi0 : ata_piix

ATA: abnormal status 0x7F on port 0xC087

scsi1 : ata_piix

Vendor: ATA Model: ST3160023AS Rev: 3.00

Type: Direct-Access ANSI SCSI revision: 05

SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)

sda: Write Protect is off

SCSI device sda: drive cache: write back

SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)

sda: Write Protect is off

SCSI device sda: drive cache: write back

sda: unknown partition table

sd 0:0:0:0: Attached scsi disk sda

Kernel panic - not syncing: Attempted to kill init!

(XEN) Domain 0 crashed: rebooting machine in 5 seconds.